SANKON Building Materials Technology Co. LTD is a one stop solutions provider for autoclaved aerated concrete (AAC) production equipment including complete AAC production lines.
We manufacture a wide range of building material machines, including block making machines, concrete panel machines, dry mortar machines, and more.
Our main products include AAC block production line,ALC panel production line,ALC panel production installation of cinstruction equipment and their matched equipment.
Our production capacity are 50,000 m³, 100,000 m³, 150,000 m³, 200,000 m³, 300,000 m³, 400,000 m³ and other scale of the AAC brick macking machine.
Block Brick Machine-50m³ Storage Container
It is a container (refer to the picture) used to store the mixing slurry.
W:ø 3600mm H:6033mm
4.Mixing technical parameter:
Helical gear reducer :CRM147-84.5-Y-18.5-V1,motor power :18.5Kw, Synchronous rotate speed 1470rpm,mixing speed17.4rpm
5.Pneumatic butterfly valve:D671X-10-150
The storage container is composed of drum, reducer, mixer and butterfly valve
The drum is cylindrical, and it is casting by the concrete
The reducer is helical gear reducer
The mixer is welded by mixing shaft, steel panel and steel pipe
The discharge is controlled by the butterfly valve.
The storage container is to store the slurry after being mixed, which will make the slurry do not solidify. The slurry will be continued to mix inside the container to avoid any solidification, and the discharge is controlled by butterfly valve.
Commissioning and adjust
The assembly of the storage container is ready and run it without any loading until the reducer rotates normally, no abnormal sound, and the mixing shaft is same with the middle line of the drum, the mixer should rotate stably.
a.Disassemble and check the reducer bearing base if the reducer run unstably and there is abnormal sound.
b.The stirring shaft is inclined, the stirring blade swings, and the adjusting device of the stirring shaft is adjusted
Maintenance and Repair:
1.Maintenance and Repai
The mixing can not stop if the slurry is stored in the container, avoid any solidification
The lubricant oil can not be lower the oil level, it should add on time. It should change the lubricant oil once per 6 months
Wash all parts every month.
When wash the container, tighten the loose parts and replace the destroyed parts.
Shut off the power before washing it and stop mixing
No one is allowed on the top of the drum when mixing.