Electrical Slurry Meter for AAC Block Vertical Cutting Machine,5m AAC Block Cutting Machinery
It is a meter (refer to the picture) used for measuring the powder before slurry feeding for mixing.
5.Pneumatic butterfly valve:D671J-10-150
The meter is composed of chamber, support ring, load sensor and pneumatic butterfly valve.
The drum shapes like a truncated cone, which make the discharge quick. It is made of rolling steel and there is washing pipe inside.
The support ring is made of steel and there is chamber on the top and the support ring below it, and there are 3 load electrical sensors hang among the chamber and support ring, and there is pneumatic butterfly valve in the discharge drum to control the program.
When the slurry is fed into the chamber, the electrical sensor will transfer the weight to the display automatically, and it will output the signal to the computer. The discharge is controlled by the pneumatic valve.
Shut off the power supply after each shift, and clean the drum wall, in order to make sure the powder weighing is accurate
Clean the dust on the sensor and weighing display.
It should follow the instruction when operate the meter
No other current is allowed to go through the electrical sensor, for example, when weld the ground wiring.
Do not sunshine the weighing display, and avoid any sudden temperature change and vibration
The meter has been calibrated before ex-factory, do not change.
No one is allowed to stand around the machine when feeding the slurry.